This project was created as a study into the parametric software itself, and how two scripts for two facades can be combined to make one.

After recreating them and grouping them according to their logic, this is what the summary I arrived to was:

In order to break them down to their core logics, this is what I arrived at

The slat wall base was composed by geometry built in Rhino and set in the Parameter nodes. The composition of the main vertical wall is captured in these two component clusters:

Building and projecting the contour onto the plane:

And building extrusions from the slat “Contouring” component above

The NEXT part of the project is the Parametric Brick Wall by Karl Singline

This is a more complicated project, but the two patterns I’m drawing from this is:

The use of a brick and applying it to the contour-based grid

And the creation of the alternating pattern (see the end):

The final results are below:

Undulating Brick Wall is a project of IaaC, Institute for Advanced Architecture of Catalonia developed at So.3: Computational Design in MAA-01 (2017-2018) by:

Students: Rana Mahran

Faculty: Aldo ?Sollazzo & Rodrigo ?Aguirre

SOURCES:

Video 1: Slat Walls by OM

Video 2: Parametric Brick Wall by Karl Singline